Design of an elevating device for bulky materials

Τίτλος

Design of an elevating device for bulky materials

Θέμα

Bulk solids

Elevating platforms

Δημιουργός

Papamichael, Michalis

Πηγή

Higher Technical Institute

Το πλήρες κείμενο είναι διαθέσιμο από το Υπουργείο Ενέργειας, Εμπορίου Βιομηχανίας και Τουρισμού

Εκδότης

Library of Cyprus University of Technology

Ημερομηνία

1989

Συνεισφέρων

Papanastasiou, N.

Nicolaides, St.

Δικαιώματα

Απαγορεύεται η δημοσίευση ή αναπαραγωγή, ηλεκτρονική ή άλλη χωρίς τη γραπτή συγκατάθεση του δημιουργού και κάτοχου των πνευματικών δικαιωμάτων.

Μορφή

pdf

Γλώσσα

en

Τύπος

text

Αναγνωριστικό

MED0029

Σύνοψη

The aim of this project is to design an Elevating device for bulky, material.
The special requirements governing the design of a conveyor, made this project difficult than performing the design of simple mechanical elements.
Drawings have been constructed and the design of the conveyor based in selected mechanisms and dimensions.
In general terms this project deals with the design of the Apron chain conveyor, used to lift bulky materials up to a height of ten meters, having an inclination of twenty degrees.
This project is divided into chapters, each chapter, being fully explained in the contents.
Procedure Followed:
The most important part in an Apron chain conveyor is the chain. Is the most critical element, due to the fact that is the element which actually carries and pull the load. Therefore, a lot of attention requires, when calculating the load chain pull-of the chain. Before chain calculations and selection, conveyor length, speed and width should be calculated.