Design construction and testing of a flash analog to digital converte

Τίτλος

Design construction and testing of a flash analog to digital converte

Θέμα

Design and construction

Analog-to-digital converters

Πηγή

Higher Technical Institute

Το πλήρες κείμενο είναι διαθέσιμο από το Υπουργείο Ενέργειας, Εμπορίου Βιομηχανίας και Τουρισμού.

Εκδότης

Library of Cyprus University of Technology

Ημερομηνία

1992

Συνεισφέρων

Hadjioannou, S

Δικαιώματα

Απαγορεύεται η δημοσίευση ή αναπαραγωγή, ηλεκτρονική ή άλλη χωρίς τη γραπτή συγκατάθεση του δημιουργού και κάτοχου των πνευματικών δικαιωμάτων.

Μορφή

pdf

Γλώσσα

eng

Τύπος

text

Αναγνωριστικό

EED0194

Σύνοψη

The purpose of this project is to design, construct and
test a flash type AID ( analog to digital ) converter.
This project also explains the principle of operation of
digital to analog conversion , introduces some digital to
analog converters as well some other analog to digital
converters. Based on the block diagram of the flash converter and its principle of operation the appropriate circuit was designed constructed and tested according to some conditions which must be fulfilled.
These conditions are as follows:
1.THE PURPOSE OF THE PROJECT IS TO DEMONSTRATE THE
PRINCIPLE OF OPERATION (GOOD ACCURACY IS NOT NEEDED)
2.THE CONVERTER WILL USE AT LEAST 10 COMPARATORS
3.AN EPROM WILL BE USED TO CONVERT THE OUTPUTS OF
THE COMPARATORS INT BCD NUMBERS
4.THE CONVERTER WILL UTILIZE 7-SEGMENT DISPLAY
The circuit was designed by examining each block
separately according to its operation and requirements, and can perform an AID conversion from 0 - 9 volts.