Press tool design for blanking and piercing operations

Τίτλος

Press tool design for blanking and piercing operations

Θέμα

Sheet-metal work

Metal-working machinery

Punching machinery

Δημιουργός

Constantinou Constantinos

Πηγή

Higher Technical Institute

Το πλήρες κείμενο είναι διαθέσιμο από το Υπουργείο Ενέργειας, Εμπορίου Βιομηχανίας και Τουρισμού.

Εκδότης

Library of Cyprus University of Technology

Ημερομηνία

1996

Συνεισφέρων

Roushas, Damianos

Δικαιώματα

Απαγορεύεται η δημοσίευση ή αναπαραγωγή, ηλεκτρονική ή άλλη χωρίς τη γραπτή συγκατάθεση του δημιουργού και κάτοχου των πνευματικών δικαιωμάτων.

Μορφή

pdf

Γλώσσα

en

Τύπος

text

Αναγνωριστικό

MED0359

Σύνοψη

This project focuses on the design, fabrication and testing of a press tool. This type of press tool is used to manufacture the end cap of an air filter.
First all the required drawings, showing all the dimensions and details of the component to be produced and the press tool, were prepared.
Continuously:
In chapter 1, the principles of blanking and piercing dies were discussed, the procedure of blanking and piercing was described and also the action of a press tool was presented.
In chapter 2 the different types of air filters and the component to be produced were mentioned.
Chapter 3 deals with the cutting parameters of the press tool like clearance and cutting forces. In the same chapter the press selection is also made.
I n chapter 4 the different parts of the press tool and their functions are covered. The designed parts are also described. The sequence of construction, materials and heat treatment for these parts are also m.e ntioned .
In cf,lapter 5, an economic appraisal of the press tool is made which inclUdes of a detail cost analysis of the production process.
Finally in chapter 6, information's about the tool usage, wear, maintenance and proper inventory control are given.