Reorganization of the HTI quality control lab

Τίτλος

Reorganization of the HTI quality control lab

Θέμα

Quality control--Statistical methods

Quality control--Study and teaching

Δημιουργός

Philippou, Philippos G.

Πηγή

Higher Technical Institute

Το πλήρες κείμενο είναι διαθέσιμο από το Υπουργείο Ενέργειας, Εμπορίου Βιομηχανίας και Τουρισμού.

Εκδότης

Library of Cyprus University of Technology

Ημερομηνία

1995

Συνεισφέρων

Messaritis, Vasos

Lazari, Lazaris

Δικαιώματα

Απαγορεύεται η δημοσίευση ή αναπαραγωγή, ηλεκτρονική ή άλλη χωρίς τη γραπτή συγκατάθεση του δημιουργού και κάτοχου των πνευματικών δικαιωμάτων.

Μορφή

pdf

Γλώσσα

en

Τύπος

text

Αναγνωριστικό

MED0414

Σύνοψη

The HTI Mechanical Engineering Department in its effort to keep up with modern ways of teaching and based on the principle of continuous improvement, decided that the Quality Control Laboratory work should be reviewed.
The existing experiments included a lot of unnecessary theory which made the study of them difficult; also the use of the computer software on quality control could not had been applied for the verification their results, simply because it was only recently acquired by HTI.
Solution to these problems was decided to be given through this final year project, which would include also a study on Statistical Process Control. The objectives of this project are the following:
• To prepare a study on the subject of "Statistical Process Control" (SPC), its specific techniques and areas of application.
• To review HTI Quality Control Laboratory work on:
1 ) Basic statistics
2)Control by attributes
3)Control by variables
• To apply and customize "SQC plus" software for the verification of the results on the above reviewed exercises.
Therefore, an effort was made so that the new experiments would be simple, containing only the basic theory and allowing for the use of a computer software.
The project is divided in 8 sections containing the following:
Chapter 1: Study on SPC
Chapter 2: Four new experiments solved
Chapter 3: Instructions as to how the trainee should use the computer to verify the results
of each experiment and the results obtained with the aid of the computer software
Chapter 4: Comments and conclusions about the project
Appendix A: Terms used and their definitions
Appendix B: References
Appendix C: Four experiments and four control charts
Appendix D: One computer diskette containing one file and one job process for each
experiment